Заказать и купить изделие «Струбцина аварийная, ТипI (шпация до 600мм под полособульб.шп-ут)» от производителя в Спб, Москве.

1.General information about the product

Product name:

Emergency clamp

Purpose:

The emergency clamp is designed for fastening wooden plasters with soft sides and wooden shields installed on holes in the hulls of ships and vessels.

2. The main technical data and device of the emergency clamp.

The main technical data of the emergency clamp are given in the table.
Type (designation)
clamp. For frame
with a flat-bulb profile, spacing up to .., mm. Clamp length, mm. Weight of the clamp, no more, kg.
ST600P 600 710 15.0
ST900P 900 1010 18.5

The device of a clamp for a frame with a flat-bulb profile is shown in the figure.

< br> 1 - guides; 2 - handle; 3 - grips; 4 & ndash; clamping screw;
5 & ndash; thrust bearing; 6 & ndash; screw; 7 & ndash; movable retainer; 8 & ndash; nut; 9 - slider.

Climatic version of the OM clamp, category I in accordance with GOST 15150-69.

3. Rules for the transportation and storage of the clamp

Transportation of the clamp according to the GOST 15150-69 group Zh2 is allowed by any type of transport. Clamp storage according to the group of storage conditions for coolant GOST 15150-69.

4. Clamp operation rules

Emergency clamps must be kept in good condition and in immediate readiness for action. When checking the readiness of the clamp for use, you should pay attention to the completeness, the absence of nicks in the thread and free movement of the nut along the entire thread, the ease of movement of the grippers and the slide nut along the guide channels; no sticking in the ball joint. Swivel and threaded connections must be lubricated.
The operation of installing the clamp is carried out as follows:
& bull; Set the clamps 3 at a distance equal to the spacing and fix with screws 6.
*; Place the grips on the frames, press the movable clamps 7 with nuts 8.
& bull; Apply the plaster to the hole and press with the screw 4 to the skin.