Заказать и купить изделие «Струбцина аварийная, ТипII (шпация до 900мм под уголковый шп-ут)» от производителя в Спб, Москве.

1.General information about the product

Product name: Emergency clamp

Purpose: The emergency clamp is designed for fastening wooden plasters with soft sides and wooden shields installed on holes in ship hulls and ships. 

2. Basic technical data and device of the emergency clamp.
The main technical data of the emergency clamp are given in the table.
Type (designation)
clamp.
For corner frame , spacing up to, mm. 
Length of the clamp, mm. Weight of the clamp, no more than, kg.
ST600U 600 710 14.5
ST900U 900 1010 18.0

The device of the clamp for the corner frame is shown in the figure.

1 - guides; 2 - handle; 3 - grips;
4 & ndash; clamping screw; 5 & ​​ndash; thrust bearing; 6 & ndash; screw; 9 - slider.

Climatic version of the clamp OM, category I according to GOST 15150-69.

3. Rules for the transportation and storage of the clamp

Transportation of the clamp according to the G2 GOST 15150-69 group is allowed by any type of transport. Clamp storage according to the group of storage conditions for coolant GOST 15150-69.

4. Clamp operation rules

Emergency clamps must be kept in good condition and in immediate readiness for action. When checking the readiness of the clamp for use, you should pay attention to the completeness, the absence of nicks in the thread and free movement of the nut along the entire thread, the ease of movement of the grippers and the slide nut along the guide channels; no sticking in the ball joint. Swivel and threaded connections must be lubricated.
The operation of installing the clamp is carried out as follows:
& bull; Set the clamps 3 at a distance equal to the spacing and fix with screws 6.
*; The grips are put on the frames, put a plaster on the hole and press the screw 4 to the skin.